Specifications - Makita 4190D Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Set plate
1-2. Battery cartridge
2-1. Depth guide
2-2. Bolt (A)
2-3. Hex wrench
3-1. Bevel scale plate
3-2. Bolt (B)
3-3. Bolt (A)
4-1. Blade case

SPECIFICATIONS

Wheel diameter
Cutting depth
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for cutting in glass and masonry
materials with a diamond wheel and water.
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Work mode : concrete cutting
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
Explanation of general view
4-2. Base
5-1. Lock-off lever
5-2. Switch trigger
6-1. Bolt
6-2. Flange
6-3. Diamond wheel
7-1. Hex wrench
7-2. Blade stopper pin
8-1. Hex wrench
Model
90°
45°
-1
)
Overall length
Net weight
Rated voltage
) : 89 dB(A)
pA
) : 100 dB(A)
WA
value (tri-axial vector
2
) : 2.5 m/s or less
h,AG
2
ENE025-1
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
ENG102-2
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
EC Declaration of Conformity
We Makita
manufacturer declare that the following Makita
machine(s):
ENG236-1
Designation of Machine:
sum)
Cordless Cutter
Model No./ Type: 4190D
are of series production and
Conforms to the following European Directives:
98/37/EC until 28th December 2009 and then with
ENG901-1
2006/42/EC from 29th December 2009
And are manufactured in accordance with the following
standards or standardised documents:
EN60745
The technical documentation is kept by our authorised
representative in Europe who is:
Makita International Europe Ltd,
Michigan, Drive, Tongwell,
Milton Keynes, MK15 8JD, England
3
9-1. Tank holder installing portion
9-2. Tank
9-3. Screw (B)
9-4. Screw (A)
9-5. Tank holder
10-1. Screw (B)
12-1. Cap
13-1. Base
4190D
80 mm
0 - 18 mm
0 - 16 mm
1,000
313 mm
1.9 kg
D.C. 9.6 V
Corporation as the
ENH101-12
responsible