Cognex In-Sight 8405 Bedienungsanleitung Seite 3

Precautions
Observe these precautions when installing the Cognex product, to reduce the risk of
injury or equipment damage:
An IEEE 802.3af compliant, and UL or NRTL listed, Power over Ethernet
l
(PoE) power source rated Class 0, 2, 3 or 4 must be used. Any other
voltage creates a risk of fire or shock and can damage the components.
Applicable national and local wiring standards and rules must be followed.
To reduce the risk of damage or malfunction due to over-voltage, line noise,
l
electrostatic discharge (ESD), power surges, or other irregularities in the
power supply, route all cables and wires away from high-voltage power
sources.
Changes or modifications not expressly approved by the party responsible
l
for regulatory compliance could void the user's authority to operate the
equipment.
Service loops should be included with all cable connections.
l
Cable shielding can be degraded or cables can be damaged or wear out
l
more quickly if a service loop or bend radius is tighter than 10X the cable
diameter. The bend radius must be at least six inches from the connector.
Class A Equipment (broadcasting and communication equipment for office
l
work): Seller and user shall be notified that this equipment is suitable for
electromagnetic equipment for office work (Class A) and can be used
outside the home.
This device should be used in accordance with the instructions in this
l
manual.
All specifications are for reference purpose only and may be changed
l
without notice.
3