Yamaha CDC-685 Bedienungsanleitung Seite 21

8 When you finish the programming for side A,
program the pause mode by pressing the TAPE
button.
* "PAUSE" lights up in the display, and after then you
can begin programming for side B.
9 Repeat steps 5 and 6 to program more tracks
for side B of the tape.
You can select the same track again.
* If "ERROR" appears in the display, the track number
just selected cannot be programmed because there is
no enough time remaining on side B of the tape.
Start recording on the tape deck and press the
w button at the same time.
The unit will pause at the end of side A of the
tape. Turn the tape over to side B. Resume
recording and, at the same time, press the w or
d button.
Notes
• In steps 7 and 9, even if "ERROR" appears in the display, you
can program another track of which time is shorter than the
remaining time on the side of the tape. At this time, if any
other track number lights up in the display, you can program
it.
• CD synchronized recording function can be used if your tape
deck is compatible with it.
In this case, in steps 10 and 11, press the SYNCHRO button
and then press the w button. Recording automatically begins.
(For details, refer to page 16.)
Notes on tape programming
• To check, cancel or correct program data, refer to page
13.
• The maximum number of tracks that can be programmed
is 40. If, however, the PAUSE mode is inserted, it is
counted as one track.
• This function can be used to program up to track number
20. If the disc has more than 20 tracks, tracks with track
number 21 and higher cannot be programmed.
TAPE
TRACK PROGRAMMING FOR RECORDING
Display information during pro-
gramming
1 2 3 4 5
SEARCH
- -
2
1 2 3 4 5
SEARCH
- 4 -
1 Shows the side of the tape and the program number for
the track to be programmed next.
2 Shows the selected disc and track number.
3 Shows the total remaining time on the side of the tape.
4 Programmed track numbers light up and programmable
track numbers among the unprogrammed ones blink.
* If "A-1" does not appear in the display after the PROG
button is pressed, press the TEXT/TIME display mode-
select button.
* If, during programming, the TEXT/TIME display mode-
select button is pressed, the program number display can
be changed to display the total remaining time on the
side of the tape. To return to the previous display, press
the TEXT/TIME display mode-select button once again.
1DISC REP RNDM SAVE BEST EDIT FILE
5DISCS S F PROG CD- TEXT
1 2 3 4 5
TITLE ARTIST TRACK
6 7 8 9 10
11 12 13 14 15
A - 1
16 17 18 19 20
1
4
1DISC REP RNDM SAVE BEST EDIT FILE
5DISCS S F PROG CD- TEXT
1 2 3 4 5
TITLE ARTIST TRACK
6 7 8 9 10
11 12 13 14 15
8 : 2 8
16 17 18 19 20
3
E-
19