Using The Appliance - Washing & Drying - Electrolux WTSL 4E200 Benutzerinformation

18 electrolux
• The display shows a time value, calcula-
ted on a default load size. If the amount
of your laundry is more or less than the
default size, the appliance adjusts auto-
matically the time value during the cycle.
• Press button
6
The door locked symbol comes on.
The drying symbol starts to flash.
The symbol of the set level stays
on.
The other level symbols go off.
You cannot set all levels for all kind of
laundry.
With the timed drying:
• Press the button
set the time value (see the «Drying Pro-
gramme» table).
The drying symbol comes on.
The anti-crease symbol comes on.
The drying time symbol comes on.
Set time value
• Each time you press this button the time
value increases by 5 minutes.
• After some seconds the set time value on
the display changes: the appliance calcu-
lates also the duration of the anti-crease
and the cooling phases.
Final time value
• Press button
6
The display shows the new time value ev-
ery minute.
USING THE APPLIANCE - WASHING & DRYING
NON-STOP PROGRAMME - WASHING
& AUTOMATIC DRYING
Caution! Do not put a plastic
device/ball for the detergent into
the drum.
• Press button
1
ance.
• Load the laundry.
to start the programme.
5
again and again to
to start the programme.
to activate the appli-
The drying symbol starts to
flash.
The door locked symbol comes
on.
If you set the time value of only 10 mi-
nutes, the appliance performs only a
cooling phase.
At the end of the programme
• The appliance stops automatically.
• The acoustic signals operate.
•
In the display
• The indicator of the Start/Pause button
6
goes off.
• The last minutes of the drying cycle the
appliance performs the anti-crease
phase.
The anti-crease symbol flashes.
The door is still locked.
• Press button
1
ance. After some minutes from the end of
the programme, the energy saving func-
tion automatically deactivates the appli-
ance.
•
When the door locked light
off you can open the door.
• Remove the laundry from the appliance.
Make sure that the drum is empty.
• Keep the door ajar, to prevent mildew
and odours.
• Close the water tap.
• Measure out the detergent and fabric
conditioner.
• Turn the programme dial to the washing
programme. The display shows the sym-
bols of the different washing phases.
Caution! Do not set a spin speed
lower than the automatic speed of
the set programme.
• Set the available options.
comes on.
to deactivate the appli-
goes