BVC C 600 Bedienungsanleitung Seite 32

central vacuum cleaner
operation manual
Usage of the HEPA filter
All BVC central vacuum cleaners are standardly delivered with a HEPA-filter, which is not
installed in the device.
When the exhaust air is routed to the outside, the HEPA-filter is NOT needed.
If it is not possible to route the exhaust air to the outside (e.g. passive house), you can use
the highly efficient HEPA filter in recirculation mode, so the indoor air remains at its best -
clean. A regular check of the HEPA filter is highly recommended. We also suggest replacing
the HEPA filter every 200 working hours.
retainers
HEPA-filter
Installing and removing the HEPA filter
Before installing or changing the HEPA filter, disconnect the main power plug. Then
loosen the screws of the motor cover and remove the cover. Turn the motor cover upside
down and set it on an even surface. Place the HEPA filter on the retainers and gently push
it down until it is completely engaged.
To remove the HEPA filter, gently push the retainers in an outward direction and lift up the
HEPA filter.
Attention:
Never operate the BVC central vacuum cleaner without a properly installed motor cover.
Always make sure that the screws of the motor cover are tightened fast.
© 2016 BVC EBS Distribution GmbH, Schweinfurt
32