Technical Specifications - Simons Voss Technologies LockNode MP Kurzanleitung

4. Technical specifications

If the cylinder does not beep, check the battery condition.
Information for SmartIntego users
SimonsVoss recommends the following procedure:
1. Remove the existing LockNode.
2. Mount the new LockNode as described.
3. Open the SmartIntego Manager.
4. Select
5. Enter the new chip ID.
6. Carry out programming in the SmartIntego tool.
7. If necessary, import into the integrator system.
8. Update the documentation (installation plan).
9 LockNode is replaced. Do not use the old LockNode
anymore.
4. Technical specifications
Dimensions
Weight
Replace with Chip ID.
16 × 18 × 7 mm
0.9 g
32 / 124 | EN