Sure Petcare Microchip Pet Door Connect Bedienungsanleitung Seite 23

When using power tools, please follow all safety instructions provided with the product.
5
6
7
8
9
1
10
4
11
Now it's time to prepare for cutting. We strongly advise that
you drill pilot holes in the corners of the outline to make it
easier to cut the hole with a jigsaw. Make sure these holes are
touching the line and that they are big enough for the blade of
the jigsaw to fit through.
Using a jigsaw, cut around the inner edge of the line you marked.
Once the hole is cut, we recommend you choose the correct
length of screw to attach the Pet Door out of those provided. Do
this by measuring the length of the screw against the depth of
your door. The screw must be roughly 20mm (3/ 4 inch) longer than
the depth of your door to hold the Pet Door in place.
Apply a line of clear all-weather sealant to the back of both
mounting adaptors, about 15mm (5/ 8 inch) from the edge. Make
sure your Pet Door is nearby and ready to be fitted. Place one of
the mounting adaptors (it doesn't matter which) over the tunnel
of the Pet Door so that the patterned side with the ribs is facing
outwards and is not touching any surfaces.
We advise that there are two people present for this step; one
person inside the house and one outside. From inside the house,
put the tunnel through the hole in the door ensuring it is going
through the centre of the hole and not touching any edges.
Remember the SureFlap logo and LCD display must be inside
the house.
From the outside of the house, check that the tunnel is in the
centre of the hole and then take the second mounting adaptor
and slide it over the tunnel with the sealant facing the door. You
may need the person on the inside of the house to keep pressure
on the Pet Door to make sure it stays in place.
Next, slide the external frame over the tunnel. Using a cross
3
head screwdriver and the length of screw you'd chosen, secure
the external frame in place. Fasten the first screw until it is
secure, but not too tight, then do the same with the remaining
2
three. Once all four screws are secure, tighten them, but make
sure to alternate between screws as you go to ensure the
product is tightened evenly.
Now, insert the four screw caps,
noting that the groove needs to be
facing away from the tunnel.
EN
22