Sure Petcare Microchip Pet Door Connect Bedienungsanleitung Seite 21

Step-by-step guide for fitting
1
20mm
2
3
4
5
6
1
7
4
Firstly, choose the correct length of screw for your installation
out of the ones provided. Measure the length of the screw
against the thickness of the glass. The screw must be roughly
20mm (3/ 4 inch) longer than the thickness of the glass.
We advise that there are two people present for the following
steps; one person inside the house and one outside. Apply a
line of clear all-weather sealant to the back of both mounting
adaptors, about 15mm (5/ 8 inch) from the edge. Make sure your
Pet Door is nearby and ready to be fitted.
Place one of the mounting adaptors (it doesn't matter which)
over the tunnel of the Pet Door so that the side with the sealant
is facing outwards and is not touching any surfaces.
From inside the house, put the tunnel through the hole in the
glass making sure the Pet Door is positioned centrally within
the hole. Press firmly on both the Pet Door and the mounting
adaptor so that you compress the sealant against the glass.
From the outside of the house, take the second mounting
adaptor and slide it over the tunnel with the sealant facing the
window. You may need the person on the inside of the house to
keep pressure on the Pet Door to make sure it stays in place.
Next, slide the external frame over the tunnel. Using a cross
head screwdriver and the appropriate length of screw out of
those provided, secure the external frame in place.
Fasten the first screw until it is secure, but not too tight, then
do the same with the remaining three. Once all four screws
are secure, tighten them, but make sure to alternate between
3
screws as you go to ensure the product is tightened evenly.
Now, insert the four screw
caps, noting that the groove
2
needs to be facing away from
the tunnel.
EN
20