JVC KD-DV5301 Bedienungsanleitung Seite 35

About sounds reproduced through the rear terminals
• Through the analog terminals (Speaker out/LINE OUT): 2-channel signal is emitted. When playing
a multi-channel encoded disc, multi-channel signals are downmixed. DTS sound cannot be reproduced.
(AUDIO—DOWN MIX: see page 30.)
• Through DIGITAL OUT (optical):
Digital signals (Linear PCM, Dolby Digital, DTS, MPEG Audio) are emitted through this terminal. (For more
details, see table below.)
To reproduce multi-channel sounds such as Dolby Digital, DTS, and MPEG Audio, connect an amplifier or a
decoder compatible with these multi-channel sources to this terminal, and set "DIGITAL AUDIO OUTPUT"
correctly. (See page 30.)
Output signals through the DIGITAL OUT terminal
Output signals are different depending on the "DIGITAL AUDIO OUTPUT" setting on the setup menu (see page
30).
Playback Disc
DVD-Video 48 kHz, 16/20/24 bits
Linear PCM
96 kHz, Linear PCM
Dolby Digital
DTS
MPEG Audio
Audio CD, Video CD
Audio CD with DTS
DivX Dolby Digital
MPEG Audio
MPEG
MP3/WMA
WAV
* Digital signals may be emitted at 20 or 24 bits (at their original bit rate) through the DIGITAL OUT terminal if the
discs are not copy-protected.
STREAM/PCM DOLBY DIGITAL/
48 kHz, 16 bits stereo Linear PCM *
48 kHz, 16 bits stereo Linear PCM
Dolby Digital bitstream
DTS bitstream
MPEG bitstream 48 kHz, 16 bits stereo Linear PCM
44.1 kHz, 16 bits stereo Linear PCM /
48 kHz, 16 bits stereo Linear PCM
DTS bitstream
Dolby Digital bitstream
32/44.1/48 kHz, 16 bits Linear PCM
44.1/48 kHz, 16 bits Linear PCM
32/44.1/48 kHz, 16 bits Linear PCM
44.1 kHz, 16 bits stereo Linear PCM
Output Signal
PCM ONLY
PCM
48 kHz, 16 bits
stereo Linear PCM
48 kHz, 16 bits
stereo Linear PCM
Continued on the next page
REFERENCES
OFF
OFF
35