capital sports Azura Fusion Benutzerhandbuch Seite 29

Secure the seat (76) to the top
of the seat post (47) using spring
3
washers (75) and bolts (74). Tighten
the bolts with the Allen wrench.
Use the Allen wrench to remove
the bolt (70) and washer (43) from
the seat post (47). Then secure the
posts (53) to the lower end of the
4
seat post (47) using bolts (70) and
washers (43). Tighten the bolts with
the Allen wrench.
Adjust the height of the seat post
5
(47) using the pin (55).
Slide the handlebar support (69)
into the shaft on the main frame
(60). Adjust the handlebar support
to the desired height and then
tighten with the knob (73). Do not
6
exceed the STOP mark! Then attach
the handlebar (71) to the handlebar
support (69) using screws (70) and
washers (43). Tighten the screws
with the Allen wrench.
EN
29