Makita DUM166 Bedienungsanleitung Seite 8

Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Take particular care and attention.
･
Read instruction manual.
･
Danger; be aware of thrown objects.
･
Keep bystanders away.
･
Cutting means continues to run after the
motor is switched off.
･
Do not expose to moisture.
･
Cd Only for EU countries
Ni-MH
Do not dispose of electric equipment or
Li-ion
battery pack together with household
waste material!
In observance
Directives,
Electronic Equipment and Batteries and
Accumulators and Waste Batteries and
Accumulators and their implementation
in accordance with national laws, electric
equipment and batteries and battery
pack(s) that have reached the end of
their life must be collected separately
and returned to an environmentally
compatible recycling facility.
Intended use
The tool is intended for cutting lawn edges or sprouts.
Noise
The typical A-weighted noise level determined according
to IEC60335:
Model DUM166
Sound pressure level (L
Uncertainty (K) : 2.5 dB (A)
The noise level under working may exceed 80 dB (A).
Model DUM168
Sound pressure level (L
Uncertainty (K) : 2.5 dB (A)
The noise level under working may exceed 80 dB (A).
Wear ear protection
Vibration
The vibration total
determined according to IEC60335:
Vibration emission (a
Uncertainty (K) : 1.5 m/s
of the European
on Waste Electric
) : 77 dB (A)
pA
) : 78 dB (A)
pA
value (tri-axial vector
2
) : 2.5 m/s or less
h
2
END010-4
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the power
•
tool can differ from the declared emission value
depending on the ways in which the tool is used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
Hedge trimming operation with optional hedge shear
blades
and
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Uncertainty (K) : 2.5 dB (A)
The noise level under working may exceed 80 dB (A).
ENE015-1
Vibration
The vibration
ENG905-1
determined according to EN60745:
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
ENG900-1
•
operator that are based on an estimation of
sum)
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
8
) : 74 dB (A)
pA
Wear ear protection
total value (tri-axial
2
) : 2.5 m/s or less
h
2
ENG901-1
ENG905-1
ENG900-1
vector sum)
ENG901-1