Herunterladen Inhalt Inhalt Diese Seite drucken

Philips FC8778 Bedienungsanleitung Seite 20

Vorschau ausblenden Andere Handbücher für FC8778:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

Problem
The rechargeable battery
can no longer be charged
or runs empty very fast.
The robot is moving in
circles.
The robot cannot find the
docking station.
Possible cause
The suction opening in the
bottom of the dust container
is clogged.
The front wheel is jammed
with hair or other dirt.
The robot is cleaning a very
dark or shiny surface, which
triggers the drop-off sensors.
This causes the robot to
move in an unusual pattern.
The robot is cleaning a floor
that reflects sunlight quite
strongly. This triggers the
drop-off sensors and causes
the robot to move in an
unusual pattern.
The rechargeable battery has
reached the end of its life.
The robot is in spiral mode.
There is not enough room for
the robot to navigate towards
the docking station.
The robot is still actively
searching.
The robot was not started
from the docking station.
Solution
Clean the suction opening (see 'Cleaning
the robot').
Clean the front wheel (see 'Cleaning the
robot').
Press the start/stop button briefly and
then move the robot to a lighter colored
piece of the floor. If the problem continues
to occur on lighter colored floors, please
go to www.philips.com/support or contact
the Consumer Care Center in your country.
Close the curtains to block sunlight from
entering the room. You can also start
cleaning when the sunlight is less bright.
Have the rechargeable battery replaced by
a Philips service center (see 'Replacing the
rechargeable battery').
This is normal behavior. The spot-cleaning
mode can be activated when a lot of dirt is
detected on the floor for a thorough clean.
It is also part of the auto cleaning mode.
After approximately one minute the robot
resumes its normal cleaning pattern. You
can also stop the spot-cleaning mode by
selecting a different cleaning mode in the
app.
Try to find another place for the docking
station (see 'Installing the docking station').
Give the robot around 20 minutes to
return to the docking station.
If you want the robot to return to the
docking station after a cleaning run, start it
from the docking station.
English
23

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis