Using This Unit; About The Status Indicator (Led) - Yamaha NX-U10 Bedienungsanleitung

1
Press POWER to turn this unit on. (The status
indicator (LED) lights up.)
2
Start playback of your computer's media
player or your portable audio player.
3
Adjust the volume level using VOLUME on
this unit.
Note
Do not unplug the USB cable from your computer during playback.
Doing so may cause your computer to freeze.
y
• When connecting to your computer, we recommend that adjusting
the volume level using VOLUME on this unit after setting the
volume level of your computer and media player to the maximum.
• When not using this unit, turn its power off to save power.
About the non-skid pad
When playing back a source with low frequency sounds, this
unit may vibrate. To get rid of the vibration noise, attach the
supplied non-skid pad.
Non-skid pad
After using this unit
1
Rotate VOLUME to set this unit's volume
level to the minimum.
2
Stop playback of your computer's media
player or your portable audio player.
3
Press POWER to turn this unit off. (The status
indicator turns off.)
Note
Do not pull forcibly on the USB cable when disconnecting it. Doing
so may damage the USB cable/plug.
6
En

USING THIS UNIT

About the status indicator (LED)

LED status
Lit
Off
Turning on and
off repeatedly
Stand
The current status of this unit
This unit is on.
This unit is off, or power supply is
not connected.
Limiter control has been activated
due to excessive input.
(Turn down the volume level until
the LED stops flashing.)