Making The Hood Opening; Installing The Rotary Switch Of The Controller; Securing The Hood - Daikin Altherma 3 H HT ECH2 O Referenzhandbuch Für Den Monteur

Fig. 3-20 Heating inflow and return flow connections aligned to the
rear
10 Slide the retaining plate between the manifold and its horizontal
mounting and insert the manifold
mounting through the middle hole of the retaining plate.
11 Secure the manifold with securing clip
mounting again.
12 Insert the two connection couplings
lateral mountings through the retaining plate.
13 Secure the two connection couplings with securing clips
(Fig. 3-20, item C) in their mountings.
14 Insert the sealing plug (Fig.
ing.
15 Secure the sealing plug with securing clip
16 Cut out side openings in the thermal insulation
item A) using a suitable tool.
Fig. 3-21 Cut-out in thermal insulation
3.4.8

Making the hood opening

1 With the heating inflow and return flow directed upwards: Cut the
hood along the perforation with a suitable tool.
Daikin Altherma ETS(X/H)(B)-D
Heat pump (indoor unit) with integrated heat accumulator
008.1447299_00 – 06/2019 – EN
(Fig. 3-20, item F) back into its
(Fig. 3-20, item G) in its
(Fig. 3-20, item B) into the
3-20, item E) into the upper mount-
(Fig. 3-20, item D).
(Fig. 3-21,
3
Fig. 3-22 Making the hood opening
3.4.9 Installing the rotary switch of the
controller
1 Place the rotary switch on the rotary switch holder of the RoCon
+ HP and press it on.
Fig. 3-23 Putting on the rotary switch
3.4.10

Securing the hood

After the installation is fully completed:
1 Attach the screws for fixing the hood (accessory bag).
Fig. 3-24 Securing the hood
2 Place the front cover straight over the rotary switch of the RoCon
+ HP. Press on the top and bottom until the front screen is se-
curely engaged again.
Set-up and installation
Installer reference guide
17