Inhaltsverzeichnis
Werbung
Injection Transformer User Manual
2.3
Safety instructions
Before operating the B-WIT 100 or B-LFT 100, read the safety instructions in this document carefully. If
you do not understand some safety rules, contact OMICRON Lab before proceeding.
Before operating always make sure that neither the B-WIT 100 or B-LFT 100 nor its accessories are
damaged.
Test setups that include the B-WIT 100 or B-LFT 100 must comply with the internal safety instructions
and all additional safety relevant documents.
In addition, observe the following safety standards, if applicable:
• EN 50191 (VDE 0104) "Erection and Operation of Electrical Test Equipment"
For your safety
The B-WIT 100 or B-LFT 100 may only be operated by trained personnel. Any maloperation can result in
damage to property or persons.
Rules for use
► The B-WIT 100 or B-LFT 100 must only be used when in a technically sound condition. The use
must be in accordance with the safety regulations for the specific job site and application.
► Always be aware of the dangers of high voltages. Pay attention to the information provided in the
documentation.
► Testing with the B-WIT 100 or B-LFT 100 shall only be carried out by authorized and qualified
personnel. Before starting to work, clearly establish the responsibilities of all personnel involved.
► Testing with the B-WIT 100 or B-LFT 100 must comply with all on-site procedures and methods for
personal safety.
► Personnel receiving training, instructions, directions or education on the B-WIT 100 or B-LFT 100
must be under constant supervision of an experienced operator while working with the equipment
on voltage levels >30 V
► Keep this manual available on site where the B-WIT 100 or B-LFT 100 is used.
► The B-WIT 100 or B-LFT 100 does not contain any serviceable parts. Do not open the B-WIT 100 or
B-LFT 100 or carry out any modifications, extensions or adaptations.
► If the B-WIT 100 or B-LFT 100 seems to be functioning improperly, please contact the
OMICRON Lab technical support (see Technical support on page 15).
Safe operation procedures
► Operate the B-WIT 100 or B-LFT 100 only under the environmental conditions specified in chapter
Technical data on page 11ff.
► Do not operate the B-WIT 100 or B-LFT 100 when explosive gas or vapours are present.
2.4
Cleaning
To clean the B-WIT 100 or B-LFT 100, use a cloth dampened with isopropanol alcohol. Prior to cleaning,
always ensure that all connections to the DUT are disconnected.
6
or >60 V
.
AC
DC
OMICRON Lab
Werbung
Inhaltsverzeichnis
