Troubleshooting - GreenWorks G24CS25 Bedienungsanleitung

7

TROUBLESHOOTING

Problem Possible cause
The guide bar The chain is too
and the chain tight.
become hot and
The oil tank is
release smoke.
empty.
Contamination
causes a block-
age of the dis-
charge port.
Contamination
causes a block-
age of the oil
tank.
Contamination
causes a block-
age of the guide
bar and the oil
tank cap.
Contamination
causes a block-
age of the
sprocket or
guide wheels.
The motor runs The chain is too
but the chain tight.
does not rotate.
The guide bar
and the chain
are damaged.
The motor is
damaged.
English
Problem
The motor runs
Solution
and the chain ro-
Adjust the chain tates, but the
tension. chain does not
cut.
Add lubricants.
Remove the
guide bar and
clean the dis-
The machine
charge port.
does not start.
Clean the oil
tank. Add new
lubricant.
Clean the guide
bar and the oil
tank cap.
Clean the
sprocket and the
guide wheels.
Adjust the chain
tension.
Replace the
guide bar and
the chain if it is
necessary.
1. Remove the
battery pack
from the ma-
chine.
2. Remove the
guide bar
cover.
3. Remove the
bar and saw
chain.
4. Clean the
machine.
5. Install battery
pack and op-
erate the ma-
chine.
If the sprocket
rotates, it means
the motor works
properly. If not,
call service cen-
ter.
9
Possible cause Solution
Sharpen or re-
The chain is
place the saw
blunt.
chain.
The chain is in Turn the chain
the incorrect di- loop to the other
rection. direction.
The chain is tight Adjust the chain
or loose. tension.
Pull the chain
brake in the di-
The chain brake
rection of the
is engaged.
user to disen-
gage it.
Make sure that
The machine the battery re-
and battery are lease button
not connected clicks when you
correctly. install the battery
pack.
The battery level Charge the bat-
is low. tery pack.
1. Push the
lock-out but-
The lock out but-
ton and hold
ton and the trig-
it.
ger are not push-
ed at the same
2. Push the trig-
time.
ger to start
the machine.
The battery is Refer to battery
too hot or too and charger
cold. manual.
EN