Limb A Tree; Buck A Log; Maintenance; Adjust The Chain Tension - GreenWorks G24CS25 Bedienungsanleitung

• Move rearward and forward and stuck the chain.
3. Use felling wedge to open the cut and let the tree
fall to the correct direction.
4. When the tree starts to fall,
a) Remove the chainsaw from the cut.
b) Stop the machine.
c) Put the machine down.
d) Go away through the escape path. Be careful
with overhead branches and your footing.
4.6

LIMB A TREE

Figure 11.
Limbing is to remove the branches from a fallen tree.
1. Keep the larger lower branches to hold the log off
the ground.
2. Remove the small limbs in one cut.
3. Limb the branches with tension from the bottom to
up.
4. Keep the larger lower branches as a support until
the log is limbed.
4.7

BUCK A LOG

Figure 12-15.
Bucking is to cut a log into lengths. Keep your body
balance. If it is possible, lift the log and hold it with
branches, logs or chock.
• When the log is held along the full length, cut it from
the top.
• When the log is held on one end,
1. Cut the first time 1/3 of the diameter from the
bottom.
2. Cut the second time from the top to complete the
bucking.
• When the log is held on two ends,
1. Cut the first time 1/3 of the diameter from the
top.
2. Cut the second time lower 2/3 from the bottom to
complete the bucking.
• When the log is on a slope,
1. Stand on the uphill side.
2. Control the chainsaw.
3. Hold the handles tightly.
4. Release the cut pressure near the end of the
cut.
NOTE
Do not let the chain touch the ground.
When bucking is complete,
1. Release the trigger.
English
2. Stop the chainsaw fully.
3. Move the chainsaw from tree to tree.
5

MAINTENANCE

Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can cause
damage to the plastic, and make the plastic
unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
5.1

ADJUST THE CHAIN TENSION

Figure 2-7.
The more you use a chain the longer it becomes. It is
therefore important to adjust the chain regularly to take
up the slack.
Tension the chain as tightly as possible, but not so tight
that you cannot pull it round freely by hand.
A slack chain may jump off and cause serious or even
fatal injury.
Wear protective gloves if you touch the chain, bar or
areas around the chain.
1. Stop the machine.
2. Loosen the chain cover by turning the chain cover
knob counterclockwise.
It is not necessary to remove the chain cover to adjust
the chain tension.
3. Turn the chain tension knob clockwise to increase
the chain tension.
4. Turn the chain tension knob counterclockwise to
decrease the chain tension.
5. When the chain is at the wanted tension, tighten the
chain cover.
5.2

SHARPEN THE CUTTERS

Sharpen the cutters if it is not easy for the chain to go
into the wood.
7
CAUTION
CAUTION
WARNING
WARNING
CAUTION
NOTE
EN