Makita BUH550 Bedienungsanleitung Seite 9

Number on adjusting dial Strokes per minute (min )
6
5
4
3
2
1
011264
CAUTION:
The speed adjusting dial can be turned only as far
•
as 6 and back to 1. Do not force it past 6 or 1, or the
speed adjusting function may no longer work.
The strokes per minute vary by the conditions of
•
battery cartridge and shear blades.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Battery adapter (Accessory)
3
1. Battery cartridge
2. Button
3. Adapter
4. Hook
5. Tool
011149
Fig.4
CAUTION:
Before using battery adapter, read all instructions
•
on tools using battery.
When charging a battery cartridge, first remove it
•
from the battery adapter and then charge it. It is not
allowed to charge the battery cartridge while using
battery adapter.
1,800
1,750
1,650
1,500
1,300
1,000
1
5
2
3
Installing or removing battery adapter
-1
Always switch off the tool before insertion or
•
removal of the battery adapter.
To remove the battery adapter, withdraw it from the
•
tool while sliding the button on the adapter.
To insert the battery adapter, align the tongue on
•
the battery adapter with the groove in the housing
and slip it into place. Always insert it all the way
until it locks in place with a little click. If you can see
the red part on the upper side of the button, it is not
locked completely. Insert it fully until the red part
cannot be seen. If not, it may accidentally fall out of
the tool, causing injury to you or someone around
you.
Do not use force when inserting the battery adapter.
•
If the adapter does not slide in easily, it is not being
inserted correctly.
The way of removing or installing a battery
•
cartridge from or on the battery adapter is the same
as that of removing or installing it from or on the
tools.
Press down the hook securely as far as it will go
•
when the battery adapter is hooked on the waist
belt and similar objects.
Arm cord hook (Accessory)
CAUTION:
Do not attach the holder of arm cord hook to other
•
than the extension cord. Do not attach it in a
position closer to the tool beyond the hook
complete hooks. Failure to do so may cause an
accident or personal injury.
2
Attach firmly one hook of the hook complete to the
•
4
tool's cord and the other hook of hook complete to
the extension cord. Working with the tool with a
sole hook only attached may cause an accident
and injury.
Using the arm cord hook helps to minimize a risk of
cutting off the extension cord unexpectedly caused by
the loose extension cord.
9