Siemens multiranger 100 Bedienungsanleitung Seite 10

Operating the MultiRanger
The MultiRanger has two modes of operation PROGRAM and RUN. PROGRAM mode lets you configure
the MultiRanger to fit your application.
MultiRanger Display and Indicator Functions
Programming
The MultiRanger is programmed by setting its parameters to match your specific application. In PROGRAM
mode, these parameter values are changed to set operating conditions.The MultiRanger is programmed
with the hand programmer. Point to the infrared port above the display and press keys.
Activating the MultiRanger
All the instructions assume that the MultiRanger is activated.
Note: On powering up, a single point unit displays distance; a dual point unit displays OFF.
1. Power the MultiRanger.
2. Point the programmer at the unit and press PROGRAM
3. Press DISPLAY
Changing Parameters
1. In RUN mode, press PROGRAM
2. Press DISPLAY
3. Enter the Parameter Number. After the third digit is entered, the parameter value is shown.
4. Enter the new value, and press ENTER
Page EN-8
RUN Mode
1 index type
2 index
3 primary reading
4 units
5 hi and hi hi alarm
designation
6 level display
7 filling display
8 emptying display
9 lo and lo lo alarm
designation
10 relay # programmed
flashing = unavailable
11 relay # activated
12 auxiliary reading
13 normal operation:
14 failsafe operation:
.
. Press DISPLAY
to select the Parameter Number field.
MultiRanger – QUICK START MANUAL
PROGRAM Mode
index type
index
parameter value
units
auxiliary function
n/a
scroll access tag
scroll access tag
n/a
relay # programmed
flashing = unavailable
relay # activated
parameter number
n/a
n/a
.
to put the unit into PROGRAM mode.
.
7ML19985QD83