Parts List; Operation - Lacor 69476 Gebrauchs- Und Instandhaltungsanleitung

1.- Lid locking button
2.- Lid handle
3.- Lid
4.- Side handle
5.- Liquid level indicator
6.- Body
7.- Dispenser tap
8.- Control panel
9.- Temperature sensor
a.-ON/OFF button
b.- SET button
c.- Temperature up button
d.- Temperature down button
e. -Display
1.- Move the locking button (1) upwards to enable you to open the lid (3) and then turn the lid
anticlockwise to remove it.
2.- Open the lid and pour the liquid into the Airpot. Make sure the liquid level NEVER exceeds the
"MAX" fill mark.
3.- Cover the body (6) with the lid and lock it using the lock button on the handle (2).
4.- Connect the power cord to a 220-240V/50-60Hz power outlet.
5.- Press the ON/OFF button (a) to turn on the product and select the temperature.
6.- Press the SET (b) button to set the temperature between 60°C and 100°C. The product
enables you to set the temperature in 5°C steps. Use the "+" button (c) to increase the
temperature or the "-" (d) button to lower it. Press the SET button once you have chosen the
desired temperature.
NOTE:
If you do not set a temperature manually, the "x" symbol will flash on the display
(e). When this process is completed and the display shows "100", the programmed
default temperature of 100°C will be activated.
7.- The temperature will be stable and it can be regulated by +/- 3°C.
8.- The heating time will depend on the amount of liquid added and the selected temperature.
9.- Pull the tap handle down to dispense the liquid. If you would like a continuous flow, move the
tap upwards and position it vertically.

PARTS LIST

3
5
7
8
c
d

OPERATION

2
1
4
6
a
e b
9
33