Swim & Fun 1639 Bedienungsanleitung Seite 48

STEP 5: CONNECTING & USING THE FLOW CONTROL VALVE
The Flow Control Valve ensures your pool
cleaner receives the flow required to ensure
optimum performance.
• Make sure the pool pump is turned OFF.
• Expel all the air from the hose.
• Attach Flow Control Valve to the male
hose (smaller end) . See Fig 7.
• Insert the Flow Control Valve into the
Weir/Skimmer. If necessary, use the Con-
trol Valve Adaptor to ensure a good con-
nection. See Fig 8.
• Turn the pool pump ON.
• Your pool cleaner will now begin automa-
tically vacuuming your pool.
The Flow Control Valve is preset between
position 3-4. This provides the ideal operating
flow in most pools. But if necessary, the flow
can be adjusted by using any setting from
Position 1 through 6 (1= minimum flow, to
slow your cleaner down, 6 = maximum flow,
your cleaner will run faster ). See Fig 9.
48
Attach Male
Hose Adaper
(smaller end)
Flow Control Valve
Control Valve Adaptor
Figure 7
Figure 8
Hose through Skimmer Ope-
ning
Flow Control Valve
Control Valve Adaptor
Figure 9
MV-1639-11-2017 . © All rights reserved Swim & Fun Scandinavia ApS
UK
Top of Skimmer