Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting - SOLIS TWIST AIR 7220 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für TWIST AIR 7220:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
3 . HUM ID I FI CATION MAT RE PLA CEME NT ALARM
The humidification mat should be changed out after 4320 hours of use, the
FILTER RESET light flashes once this time has come. In this case, switch the
appliance off, pull the power adapter and disassemble the appliance as described
in the section "Cleaning the humidification mat" (Steps 2+ 3). Replace the
old humidification mat with a new one. Reassemble the appliance completely
and refill the water basin with water as described in the section "Cleaning the
humidification mat" (Step 5 + 6).
Caution: Before restarting the appliance after replacing the humidification mat,
GB
you have to reset the appliance.
Resetting the appliance after replacing the humidification mat:
To reset the appliance timer to 4320 operating hours after replacing the humid­
ification mat, touch and hold the ON/OFF button
until a signal sounds. Like that, you will be automatically reminded to replace
the humidification mat.
C LEA NI NG THE CH AS SIS
Regularly clean the chassis with a slightly moist towel and some mild detergent.
In general, do not use any aggressive or abrasive detergents or metal sponges
for cleaning, as these might damage the surface.
88
;
one time for 3 seconds

TROUBLESHOOTING

s
Problem
Possible cause
The appliance
– The power adapter is not
does not work.
connected to the power
outlet.
– Water basin is empty.
No
– The power adapter is not
humidification
connected to the power
power.
outlet.
– The ON/OFF button
lights up red.
The room air
– The humidification mat
is not properly installed.
humidity does
not change.
– The humidification mat
is dirty.
– Doors or windows are
open.
– The room is too large.
The escap-
– The water basin is filled
ing air smells
with old water.
unpleasantly.
Solution
– Make sure that the appliance is
connected to the power mains
and is switched on.
– Make sure that the water basin is
filled with tap water and that the
appliance is correctly assembled.
GB
– Make sure that the appliance is
connected to the power mains
and is switched on.
– Switch the appliance off. Fill the
water basin with fresh water and
restart the appliance.
– Make sure that the humidification
mat is properly installed.
– Make sure that the humidification
mat is clean. If necessary, clean it
as described on page 87.
– Make sure that all the windows
and doors are closed.
– Make sure that the room size
does not exceed 44 m² resp.
105 m³.
– Drain the water and clean the
appliance as described in
" Cleaning and maintenance " .
Fill the water basin with fresh tap
water.
89

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis