KERR Maxcem Elite Chroma Bedienungsanleitung Seite 7

seconds. See footnote for recommended curing times for other curing light models.**
10. For metal-based and opaque restorations such as PFM and Zirconia, it will not be possible to light cure the
cement. Before proceeding to finishing and polishing, ensure that the cement has been allowed to cure for at
least 4 minutes after seating.
11. If needed, use finishing strips for proximal areas. Polish margins with Gloss Plus discs, cups, or points. Use Hi-
Luster Plus polishers for a final high luster shine.
12. Verify the occlusion.
For additional guidance, refer to the printed technique guide included in the packaging.
Implant Restorations
1. Prepare the implant abutment per manufacturer's instructions.
2. If needed, clean the abutment and air dry.
3. Seat the restoration to ensure proper fit. After try-in and occlusal adjustment, thoroughly clean the bonding
surface of the restoration.
4. Select the desired shade of Maxcem Elite Chroma.
5. Follow the steps 7 – 12 in the "Cementation" section for crowns above.
Veneer Restorations
For cementation of veneers (ideal for 1-2 units at a time), an adhesive must first be applied to the tooth. For best
results, select OptiBond™ Solo Plus† Adhesive or OptiBond XTR†† Self-Etch Universal Adhesive. Consult adhesive
product instructions for use.
After adhesive is applied and cured, follow the instructions for cementation:
1. Select the desired shade of cement.
2. Remove the syringe cap. Before the first use, bleed the syringe by squeezing out a small quantity of pastes from
each side onto a pad to equalize the base and catalyst paste in the syringe. Secure the appropriate automix tip
on the dual syringe cartridge by turning the tip clockwise.
5