KERR Maxcem Elite Chroma Bedienungsanleitung Seite 6

application.
Cementation
7. Dispensing of the material is done as follows:
Inlay/Onlay - Dispense the cement directly into the preparation covering all surfaces.
·
restoration with moderate pressure.
Crown
· - Fill the crown with cement.
· Post - Prepare the post space. Size and fit the post. Dispense the cement onto the post and directly
into the canal space using the root-canal tips. Seat
trapping air. Allow the cement to slowly flow from canal space.
8. Maxcem Elite Chroma has a gel-state color indicator which visually displays the optimal time to remove excess
cement. The cement turns pink when dispensed from the syringe and the pink color will disappear once the
cement reaches its gel state, indicating ideal timing for excess cement removal with a scaler or explorer. For the
Seat the restoration with moderate pressure.
and rotate the post slightly upon insertion to
best cleanup experience, follow one of the following options:
· Option 1 – Self Cure: Wait until the pink color in the cement fades away before initiating clean-up.
This will take approximately 2 minutes, though the color change is the best indication of the gel-state.
Maintain pressure on the restoration while removing excess cement, and until the cement has fully set.
Seat the
· Option 2 – Tack Cure: You can initiate the gel-state by tack-curing excess cement with a curing light for
approximately 2-3 seconds (pink color will disappear
ly removed with a scaler or explorer.
Option 3 – Immediate Removal: Remove all uncured pink-colored excess cement using a sponge
·
avoid
pellet or microbrush while maintaining pressure on the restoration. Cover the margins with Kerr NX3
Try-in gel or a glycerin gel of your choice. Immediately light-cure all surfaces including margins using
Demi Ultra curing light for 10 seconds or allow the cement to self-cure for at least 4 minutes after seating
of the restoration. Rinse glycerin gel off with water. Proceed directly to step 10.
9. After removal of the excess cement, light cure all surfaces including margins using Demi Ultra curing light for 10
4
immediately). Excess cement should be immediate-
Maintain pressure on the restoration while removing excess cement.