involight SlimPAR1266 Bedienungsanleitung Seite 23

AUTOMATIC CONTROL:
Press the "Menu" button repeatedly until the display shows
program. Press "Enter" again to select
now set the desired automatic program.
MUSIC CONTROL:
"Sound"
Press "Menu" until
"SO-1"
program
program
PROCEDURE OF THE PROGRAM:
Press the "Menu" button until
again to select the speed
desired speed of the program..
MICROPHONE SENSIBILITY:
The sensitivity with which the headlamp reacts to the music signals (bass impulses).Press the "Menu" button until
"Sens".
the display shows
select the microphone sensitivity
set the desired microphone sensitivity. The height is the value, the more sensitive the microphone reacts to the
music signals (bass impulses) in the environment.
SILENT-MODE:
The Silent mode refers to the music-controlled operation and is also known as Intelligent Sound Control. If the
silent mode is activated "ON" and the microphone of the device does not receive any music signals (bass
impulses), the light beams of the device switch off (BLACKOUT). If the silent mode is deactivated "OFF", the
current program of the device will continue slowly, even if no further music signals (bass impulses) are received.
"SILE"
Press "Menu" until
Press "Enter" again to select
silent mode "ON" or deactivate "OFF".
IRC-CONTROLLING:
Press the "Menu" key until the display shows
"ON"
again to select
control "ON" or deactivate "OFF".
DMX-MODE:
To select the DMX mode and set the start address, press "Menu" button until the
Press "Enter" again to select
"Setup" again to select DMX start address
can now set the desired start address.
MASTER/SLAVE-OPERATION:
The "SlimPAR1266" can be linked to other devices. To set a device as a „Slave", press the „Menu" button until the
„ Slav"
display shows
interconnected devices are now working synchronously.
"AU-1"
is displayed. Sound mode is activated. Press "Enter" again to select sound
"SO-2".
to With the "Up" and "Down" buttons you can now set the desired sound
"SPED"
appears on the display. The flow rate menu is displayed. Press "Enter"
"SP-1" "SP-9"
to
The microphone sensitivity menu is displayed. Press
"SE-1"
is displayed. The menu for silent mode is displayed.
"ON" "OFF".
or
"OFF".
or With the "Up" and "Down" buttons you can now activate the IR remote
"2CH" "3CH"
,
. Confirm with the „Enter"key. Select the desired program on the master device. The
"Auto".
"AU-2"
to
. With the "Up" and "Down" buttons you can now set the
"SE-9".
to With the "Up" and "Down" buttons, you can now
With the "Up" and "Down" buttons you can now activate the
"INFR".
The IR remote control menu is displayed. Press "Enter"
"4CH"
,
"d1" "d512".
to
22
Now the unit plays the automatic
. With the "Up" and "Down" buttons, you can
"Enter"
"ADDR"
"6CH" "10CH"
, , or
With the "Up" and "Down" buttons, you
again to
display appears.
mode. Press