Moulinex Archipel 60 C HE5 41 Gebrauchsanleitung Seite 11

- Empty the tank.
- Plug in the iron again to dry the soleplate,
which should be done over a cloth (watch
out for any splashes of water and steam).
- After this operation, unplug the iron again
and allow it to cool before cleaning the
soleplate.
- Clean the soleplate (cold iron) on a piece of
thick, clean, damp cotton before putting
away the iron or before using it again.
Note :
Moulinex strongly recommends that you do
not use descaling products (powder or liquid).
Storage
After each use:
- Unplug the iron.
- Set the control button (C) to the " " posi-
tion.
- Empty the tank.
- Allow your iron to cool down.
- Wind the power cord.
- Store the iron standing on its heel.
What to do if your appliance
does not work
Problems
The iron does not Bad connection
heat up.
Thermostat control
button (D)
on Min.
No steam and the Steam control button Set steam control
iron is hot. steam (C) is in the
« » position.
The tank is empty.
Water runs out of Iron used with steam Wait for the
the holes in the before temperature
soleplate during use control indicator
light (E) goes out
Steam is being used Set the thermostat
outside the steam
zone of the
thermostat button
(D).
The spray does not The tank is empty.
work.
Causes Remedies
Check the
socket.
Adjust the
thermostat
control button (D).
button to the
desired steam
setting.
Fill it.
temperature
indicator light (E)
to goes out for the
first time before
moving to the
steam position.
button (D) to the
steam zone
indicated.
Fill it.
Severe reduction
in flow of steam.
The iron is leaving
brown marks on the contained or con-
laundry.
Water runs out of
the holes in the
soleplate
during storage
If you have followed all these instructions
and your iron still does not work, please
contact an approved Moulinex service centre
(see the booklet " Moulinex Service ").
Ironing guide
. Which temperature to use
Refer to the labels on your laundry to find out
the composition of the fabrics and ironing
instructions.
Ironing
instructions
. If the composition of the fabrics is a mixture
of several sorts of textile, set the thermostat
control to the lowest recommended
temperature. If you cannot find the compo-
sition of the fabrics from the label, do a test
in a place which will not be seen, starting at
the minimum temperature.
. Woollen fabrics can be ironed using steam.
Place a dry cloth over the textile to be ironed
or iron it on the reverse side.
. To avoid making delicate fabrics shiny (silk,
velvet, viscose, etc.) or for fabrics with im-
11
Iron is starting to Perform an auto-
scale up. clean.
The tank is almost Fill it.
empty.
The water used Perform an
auto-clean
tains organic and change the
residues. water. Consult the
section on
«Recommended
water».
Iron stored flat Set the steam
with water in control button
the tank. (C) to «
store the iron
standing on its
heel. Empty the
water out of the
iron.
Types of textile Thermostat
Acrylic, polyamide
polyester, viscose
Wool, silk
Cotton
Thick cotton, linen
Warning: do not iron this article.
» and
.
..
...
MAX