FAAC E850S Bedienungsanleitung Seite 32

OPENING TO THE RIGHT
 9 Opening to the right
function
closing
closing deceleration
opening deceleration
opening
1. Close the gate as far as the required closed position. The closed
position must be at least 10 cm from the external mechanical stop.
2. Using a screwdriver, turn screw number 2 clockwise until the cam
engages the micro switch, as shown in  5 1. When the micro
switch is activated, the LED DL6 (CL) turns off.
3. Open the gate as far as the required closing deceleration starting
point.
4. Using a screwdriver, turn screw number 1 clockwise until the cam
engages the micro switch, as shown in  5 2
switch is activated, the LED DL8 (R.CL) turns off.
5. Open the gate as far as the opening deceleration starting point.
6. Using a screwdriver turn screw number 4 anticlockwise until the
cam engages the micro switch, as shown in  5 3. When the
micro switch is activated, the LED DL7 (R.OP) turns off.
7. Open the gate as far as the required open position. The open
position must be at least 10 cm from the external mechanical stop.
8. Using a screwdriver turn screw number 3 anticlockwise until the
cam engages the micro switch, as shown in  5 4. When the
micro switch is activated, the LED DL5 (OP) turns off.
!
Tighten the central screw of the limit switch unit by one turn (55).
Replace the cover of the limit switch unit using the screws that were
put aside previously ( 5 6).
Kit E850S
direction of
cam to be adjusted
adjustment

cam 2

cam 1

cam 4

cam 3
When the micro
4 -R.OP - 
3 - OP - 
16
2 -CL - 
51
1 -R.CL - 
52
53
54
55
56
532181 - Rev.A