FAAC E850S Bedienungsanleitung Seite 28

ELECTRIC MOTOR
1. Make a hole in the cable gland seal. Insert the electric motor
cable into the cable gland seal ( 3 1-1).
2. Remove the three-pole terminal from J3 or J4.
3. Connect the wires of the motor to the three-pole terminal follow-
ing the colours indicated in  3 1 .
4. Plug the wired three-pole terminal wired into:
- J3 if the gate opens towards the left
- J4 if the gate opens towards the right
 
The direction in which the gate opens refers to when looking at the
gate while standing in front of the C850.
J4
J3
OPEN SX
J3
M
3
FLASHING LIGHT
Insert the cable of the flashing light into the cable gland seal indicated
in  3 3. Connect the flashing light (230 V~, max 30 W model), to
terminals of J2 ( 34).
the LAMP
COOLING FAN
The board cooling fan is connected at the factory to J8 ( 3 5).
The fan is powered by a DC voltage. The connection is therefore
polarised.
The fan is started and stopped by the board according to the temper-
ature of the component to be cooled.
Kit E850S
1
MOTOR
OPEN DX
J4
RADIO RECEIVER/DECODER BOARD
The quick insertion connector JP1 is specifically for 5-pin FAAC radio
or decoder boards.
It is a polarised type of connector (36).
 
If a FAAC model RP receiver is used, it is recommended to install the
appropriate external antenna in order to obtain a sufficient range.
LED
The LED remotely indicates the status of the gate as follows:
gate status
closed
opening
open
closing
Insert the cable of the LED into the cable gland seal indicated in
 3 7. Connect the LED (model 24 V
W.L. and - terminals of J7 (38).
ACCESSORIES POWER SUPPLY
The E850S supplies 24 V
on the +24V and - terminals of J7 ().
J2
 3 1
J8
 3 2
J7
12
LED status
off
on
on
flashing
"
, maximum 0.2 A) to the
"
max. 0.5 A for the connected accessories,
J2
230V~
30W
33
35
J7
24V
0.2A
37
532181 - Rev.A
3 4
JP1
3 6
3 8