Installation; Standard Delivery; Appliance Installation - AEG GYE01016UE Benutzerinformation

Service Centre or an electrician to
change a damaged mains cable.
• The electrical installation must have
an isolation device which lets you
disconnect the appliance from the
mains at all poles. The isolation
device must have a contact opening
width of minimum 3 mm.
An appropriate socket or
adapter for the Schuko plug
should be used if necessary.
The water heater needs to
be connected to the
protective conductor.

3. INSTALLATION

3.1 Standard delivery

The following are delivered with the
appliance:
• Wall mounting bracket.
• Two locking ring fitting G ½ x 15
(delivered only with GYE01016UE +
GYE01516UE).
3.2 Placement
The sealed unvented
(pressurised) appliance is
only suitable for undersink
installation. The appliance is
intended for heating cold
water and to supply one or
several draw-off points.
The appliance may only be installed with
pressure taps in conjunction with a type-
examination tested safety valve.
The type-examination tested safety valve
protects the appliance against
unacceptable excess pressure.
WARNING!
Do not install the appliance
in the following places:
• Outdoors.
• Areas that are cold and
• Where water discharge is
freezing, the freezing
water may damage the
internal tank and pipes.
not possible.
2.4 CE designation
The CE designation shows that the
appliance meets all essential
requirements according to the:
• Low Voltage Directive.
• Electromagnetic Compatibility
Directive.
• RoHS directive.
Ensure that the appliance is
freely accessible for
maintenance work.
Always install the appliance vertically and
near the draw-off point.

3.3 Appliance installation

The appliance is designed for installation
on a solid wall. Ensure the wall offers
adequate load bearing capacity.
Always install the appliance
vertically in a room free from
the risk of frost and near the
draw-off point.
1. Mark out the holes to be drilled on
the wall.
2. Drill the holes and insert suitable rawl
plugs.
3. Secure the wall mounting bracket
using suitable screws.