AEG GYE01016UE Benutzerinformation Seite 12

Problem
The appliance does not sup-
ply hot water.
Water can only be drawn at
a reduced rate.
Loud boiling noises inside
the appliance.
Water drips from the safety
valve after heat-up.
Water leaks.
If you cannot remedy the
fault, notify your qualified
contractor. To facilitate and
speed up your enquiry,
please provide the following
numbers from the type
plate :
• PNC (9 digits)
• SN (8 digits)
Cause
The temperature selector is
set to "*".
No power at the appliance.
The high limit safety cut-out
has tripped.
The controller is faulty.
The flanged immersion heat-
er is faulty.
The aerator in the tap is
scaled up or dirty.
The appliance is scaled up.
The safety valve is scaled up
or dirty.
Improperly sealed, hot or
cold water source connec-
tions.
Remedy
Switch the appliance ON by
turning the temperature se-
lector.
Check the plug / fuses in the
fuse box.
Remedy the cause of the
fault. If necessary, replace
the combined temperature
controller / high limit safety
cut-out. Make the high limit
safety cut-out operational by
pressing the reset button on
the high limit safety cut-out
(see chapter 7.5).
Replace the combined tem-
perature controller / high
limit safety cut-out.
Replace the flanged immer-
sion heater.
Descale / replace the aera-
tor.
Have the appliance descaled
by a qualified contractor.
Switch the appliance off. De-
pressurise the appliance by
disconnecting it from the
power and water supply.
Have the safety valve
checked by a qualified con-
tractor.
Tighten threaded connec-
tions.