Special Information - AEG GYE01016UE Benutzerinformation

Correct functioning of your appliance does not only
•
depend on product quality, but on correct installation
by a qualified professional.
Never remove or damage stickers, warning labels or
•
nameplates attached to the appliance.
A qualified technician carrying out the installation is
•
obliged to observe applicable national standards and
regulations concerning connection to the water
distribution system and the electric network. The
manufacturer is not responsible for any unprofessional
or incorrect installation.
Check that the specifications written on the
•
appliance's identification plate are the same as those
of the electrical power supply.
This appliance is manufactured and tested in
•
accordance with valid regulations.
The operating water pressure (minimum and
•
maximum) must be between 0,1 bar (0,01 MPa) and 10
bar (1,0 MPa).
To prevent scalds while using the water heater, always
•
check the water temperature and adjust as needed
before use.
In the case of faults, a peak temperature of up
to 99 °C may briefly occur in the system.

1.3 Special information

When permanently connected to the power supply
•
using a dedicated junction box, the appliance must be
able to be isolated from the mains power supply by an
isolator that disconnects all poles with at least 3 mm
contact separation.
The power cable may only be replaced (for example if
•
damaged) by a qualified contractor authorised by the
manufacturer, using an original spare part.
Secure the appliance as described in chapter "3.3".
•
Observe the maximum permissible pressure (see
•
chapter "9.4").