How To Display Consumption Measured By Pulse Meters Connected To Iperbus - urmet 1717/12H Bedienungsanleitung

Water alarm
Gas alarm
Fire alarm
Door open alarm
Intrusion alarm
Generic alarm
Power/consumption limit exceeded alarm
the alarm. The second alarm will appear, and so on until all the stored alarms have been deleted from
memory.
Energy/consumption limit alarms detected on IPerBus will be shown after all the pending alarms have been
displayed.
2.5 HOW TO DISPLAY CONSUMPTION MEASURED BY PULSE
METERS CONNECTED TO IPERBUS
Select on the Home Page and then
meters on IPerBus (if the bus is set to ON). Up to four pulse meters can be selected and the instantaneous
power reading of each one will be shown.
..i
The user can select the pulse meter to be displayed by selecting the corresponding icon (e.g.
Total monthly consumption
always be zero at this time.
Check correct operation of the meter and/or correct wiring if one or more pulse meters connected
to IPerBus shows an instantaneous power reading of 9.9 kW.
DS1717-008
Alarm priority table
to access the menu to display consumption measured by pulse
will be available in future developments of the product. This value will
..m
1i
1m
1 2
PRIORITY
MAX
MIN
1.2 kW
0 kWh
3 4
X or to delete
for the
1
27