Interactions Between Alarms On Iperbus And Door Phone Functions; Multiple Alarm Display Priority - urmet 1717/12H Bedienungsanleitung

Touch the X icon (or
• The alarm may be deleted from the MODO monitor (*) by touching the X icon on the display or
The beeping will stop and the display will be switched off by touching either icon.
Without actions by the user:
• The beeping will stop after 1 minute and the display will be switched off but the
on to indicate a pending alarm. The
cancelled.
• The pending alarm will be repeated with the same methods (display on with alarm icon and beeping for
1 minute) after 15 minutes and after 30 minutes. The alarm will be repeated again also if the condition
which generated the alarm on IPerBus has ceased in the meantime.
• Switch MODO on from the ON/OFF button to view the pending alarm (
beeping will be heard and the alarm will be cancelled (*).
(*) IMPORTANT
2.3 INTERACTIONS BETWEEN ALARMS ON IPERBUS AND DOOR
PHONE FUNCTIONS
• The conversation will be interrupted and the alarm page will appear if an alarm occurs during a
conversation. The alarm cycle illustrated above will be repeated.
• A call arriving while a warning is being displayed (and while beeping) can be accepted. In this case, the
alarm will be stored directly and not shown again (

2.4 MULTIPLE ALARM DISPLAY PRIORITY

Multiple IPerBus alarms which are not deleted as they appear (e.g. because the user is away) will be stored.
The LED will appear to indicate this condition.
Switch MODO on using the ON/OFF button to view them: the alarms will appear one at a time starting from
the alarm with the highest priority as shown in the following table.
26
ALARM
LED will remain on until the pending alarm is examined and
LED).
LED will remain
LED) and stored 1 minute
X icon or . In this case, no
DS1717-008
.