Printer Menu; Setup Menu - Seiko H2-104S Schnellreferenz

#RESEAT PRINTHEAD
Used to check the print head.
>
#WASH PRINTHEADS To prevent the nozzle from clogging, this function is provided to fill the cap with ink so that the print head
> (nozzle surface) is soaked in the ink.
PRINTER MENU
Menu
#CONFIG PRINT
Used to print the printer information and operation panel setting information.
>
#ERROR LOG PRINT
Used to print the error log information saved in the printer.
>
#HISTORY PRINT
Used to print the ink system cleaning status and the print head replacement log saved in the printer.
>
ADJUST MENU
Menu
#NOZZLE PRINT Print a pattern to check print condition such as missing dots, and set the clogged nozzle numbers based on the
#EXECUTE print results.
#PRINT HEAD ADJUST Print a head position adjustment pattern, and enter the head position adjustment value and the L to R
#EXECUTE adjustment value based on the print results.
#EDGE SENSOR ADJUST Print a sensor position adjustment pattern and enter the adjustment value for the media horizontal direction
#EXECUTE (side direction) based on the print results.
SETUP MENU
Menu
#LANGUAGE
Select the language of messages used for LCD.
>JAPANESE
#TIME ZONE (GMT+)
Select a time zone.
>YY/MM/DD HH:MM ZZZ
#LENGTH UNITS
Select a length unit.
>MILLIMETER
#TEMPERATURE UNITS
Select a temperature unit.
>CENTIGRADE
#BEEP(UNCAP CARRI) Set whether to emit a warning beep in the state below.
>ON - The print head is dislocated from the cap in the daily maintenance or head height adjustment.
- The print head cannot be capped due to a media jam error during printing.
#BEEP(TUR TIMEOUT)
Set whether to emit a warning beep when a take-up (TUR) timeout has occurred.
>ON
#BEEP(INK ERROR)
Set whether to emit a warning beep when an ink error has occurred.
>ON
#BOOT VERSION
Displays the BOOT version.
*X.XX
#PRINTER FW VER
Displays the system firmware version.
*X.XX_YY
#MAIN PCA VER
Displays the version of the IPB board.
*XXXXX
#ACT PCA VER
Displays the version of the ACT board.
*X.XX
#CARRIAGE PCA VER
Displays the version of the HCB board.
*XXXXX
#BTC VER
Displays the version of BTC (FPGA).
*XXX
#USB ADDRESS
Displays the USB address.
*XXX
#USB SPEED
Displays the transfer speed of USB connection.
*HIGH-SPEED
#FACTORY DEFAULT
Sets all parameters to the initial settings at factory shipping.
>
#PRINTER FW UPGRADE
Sets the printer to the online update mode.
>
HEATER MENU
Menu
#HEATER STANDBY TIME
>30 min
Select the time to maintain the standby set temperature of the heater (including the time for
transition to the standby set temperature) after printing.
Outline of functions
Outline of functions
Outline of functions
Outline of functions
53