Setting Items; Media Menu - Seiko H2-104S Schnellreferenz

Setting items

INK MENU
Menu
XXX INK LEVELZZZ% INK LEVEL shows remaining ink. DATE shows the manufactured date of ink cartridge.
DATE:YY/MM/DD
MEDIA MENU
Menu
ROLL(XXXXXX) XXXXXX: Media name
YYYmm YYYY: Media width
SHEET(XXXXXX) XXXXXX: Media name
YYYYmm YYYY: Media width
FACE(XXXXXX) XXXXXX: Media name
YYYYmm YYYY: Media width
BACK(XXXXXX) XXXXXX: Media name
YYYYmm YYYY: Media width
NEST(XXXXXX) XXXXXX: Media name
YYYmm YYYY: Media width
MEDIA REG MENU
Menu
#SELECT MEDIA
Select the media number of media to be registered or parameter-corrected.
>XX:YYYYYY
#RENAME MEDIA Name (register) the media number selected in [SELECT MEDIA]. Six (6) digits of character (or code) can be
>XX:YYYYYY entered for the media name. For character string of 6 digits, codes, alphanumerics and katakana characters can
be used.
#SMART PASS
Select the intensity for the auto correction function which ameliorates the print quality (unevenness, etc).
>XX:LOW
#DENSITY
Select a print density.
>XX:NORMAL
#PRINT DIRECTION
Select a print direction.
>XX:BIDIR
#USE EDGE GUARD
Select whether to use the media edge guard or not.
>XX:YES
#SKEW CHECK
Select whether to perform a skew check when printing.
>XX:ON
#MEDIA ADV MODE
Select a media advance mode.
>XX:FWD ONLY
#MEDIA BACK MODE
Select a media advance mode.
>XX:BACK & FWD
#SUCTION FAN LEVEL
Select the force (air volume of fan) to suck the media to the platen.
>XX:HIGH
#AFTERHEATER T
Set the afterheater temperature. However, when "**" is set, the postheater does not work.
>XX:30°C
#PRINTHEATER T
Set the printheater temperature. However, when "**" is set, the print heater does not work.
>XX:40ºC
#PREHEATER T
Set the preheater temperature. However, when "**" is set, the preheater does not work.
>XX:40°C
#COLOR STRIPE
Select whether to print color stripes or not.
>XX:ON
#PH HEIGHT VAL
Adjust the print head height.
>XX:+0.0
#PH CLEANING
To keep the print head condition, select a cleaning mode which is automatically performed by the printer.
>XX:START & END
#ADVANCE PREF
Select the media advance adjustment value priority.
>XX:SOFTWARE
#PRINT MODE PREF
Select smart pass, density and print direction priorities.
>XX:SOFTWARE
#HEATER PREF
Select the heater temperature setting priority.
>XX:SOFTWARE
#PH REST PERIOD Scanning of the print head rests at every certain print length during printing. Set this time period to prevent
>XX:0000CYCLES missing dots when printing. Normally, set it to [0000CYCLES].
#PH REST TIME Corresponding to [ PH REST PERIOD], set the scan rest time. When [0] is set for [PH REST PERIOD], this parameter
>XX:10sec is ignored. Set this rest time to prevent missing dots when printing. Set it to [10 sec] as a rule of thumb.
#MEDIA ADV VALUE Set MEDIA ADVANCE VALUE. Set the advance value so that the banding (horizontal stripes of path splicing) is
>XX:YYY.YY% not visible.
Outline of functions
Outline of functions
Outline of functions
51