Preparations; Power Supply; Loading And Replacing The Batteries - Metz MECABLITZ 34 CS-2 Bedienungsanleitung

62

Preparations

Preparations
Preparazione Preparazione
Voorbereiden Preparación
Fig. 1
Fig. 1
Fig. 1
Fig. 2
Fig. 2
Fig. 2

Power supply

The flash unit should only be powered by 2 CR2 lithium
batteries. This type of battery can be stored for many years
with virtually no loss of power, thus making it ideal for
occasional use.
The batteries are exhausted if the recycling time at full
light output exceeds 60 seconds. Remove the batteries
from the mecablitz if it is not going to be used for an exten-
ded period.

Loading and replacing the batteries

• Turn off the flashgun by its main switch
• Press the unlocking button
compartment cover to the right and fold open (fig. 2).
• Insert the batteries as indicated by the symbols in the
battery compartment.
The supplied lithium batteries are consumables and not
subject to our guarantee conditions.
After the batteries have been loaded, fold down the battery
compartment cover and push back to the left until it be-
comes audibly engaged.
.
(fig. 1), slide the battery