Denon DJ X1850 PRIME Benutzerhandbuch Seite 10

5. Master Outputs (unbalanced RCA): Use standard RCA cables to connect these outputs to
loudspeakers or an amplifier system. Use the Master knob on the top panel to control the
volume level.
6. Record Outputs (RCA): Use standard RCA cables to connect these outputs to a recording
interface, external mixer, or other device. Use the Utility menu to select whether or not the mix
sent to these outputs will include the microphones' audio signal (see
> Microphone).
7. Booth Outputs (1/4"/6.35 mm, TRS): Use standard 1/4"/6.35 mm cables to connect these
outputs to booth monitors or a booth amplifier system. Use the Booth knob on the top panel to
control the volume level. Use the Utility menu to select whether or not the mix sent to these
outputs will include the microphones' audio signal (see
Microphone).
8. Send Outputs (1/4"/6.35 mm, TRS): Connect these outputs to the inputs of an external effects
module or other device. You can use the Utility menu to set the level of this audio signal (see
Operation > Utility Menu > Advanced
9. Receive Inputs (1/4"/6.35 mm, TRS): Connect these inputs to the outputs of an external effects
module or other device. You can use the Utility menu to set the level of this audio signal (see
Operation > Utility Menu > Advanced
10. Phono/Line Inputs (RCA): Use standard RCA cables to connect these line-level or phono-level
inputs to an external audio source. Use the input selectors on the top panel to set whether the
signal from the line-level inputs or phono-level inputs will be sent to each channel.
11. Grounding Terminal: If you are using phono-level turntables with a grounding wire, connect the
grounding wire to this terminal. If you experience a low "hum" or "buzz", this could mean that
your turntables are not grounded.
Note: Some turntables have a grounding wire built into the RCA connection and, therefore,
nothing needs to be connected to the grounding terminal.
12. Mic 2 Input (1/4"/6.35 mm, TRS): Use a standard 1/4" (6.35 mm) cable (not included) to connect
a standard dynamic microphone to this input. Use the Mic 2 Level knob on the top panel to
control the volume level.
13. MIDI Output (5-pin DIN): Use a standard MIDI cable to connect this output to the MIDI input of
an optional external MIDI device. You can use the MIDI Send button to send MIDI Start
messages from this output. You can also use the Utility menu to enable or disable this
connection (see
14. Digital In (digital RCA): Use digital RCA cables to connect these 24-bit/96 KHz inputs to the
digital outputs of your compatible Denon DJ media players.
15. Digital Link In (digital RCA): If you are using more than one X1850 PRIME unit, use a digital RCA
cable to connect this input to the digital out of another X1850 PRIME.
16. Digital Out (digital RCA): Use a digital RCA cable to connect this output to the digital input of
another X1850 PRIME unit or an external interface, mixer, or other device. Use the Utility menu to
set the level of the outgoing signal (see
10
Operation > Utility Menu >
Audio).
Audio).
System).
Operation > Utility Menu > Advanced
Operation > Utility Menu
Operation > Utility Menu >
Audio).