Denon DJ X1850 PRIME Benutzerhandbuch Seite 14

Filter
•
Resonance: This is the resonance of the filters on Channels 1–4 (i.e., how much the frequencies just
beyond the cutoff frequency are allowed to pass through the filter). 0 is a flat setting (frequencies just
beyond the cutoff frequency won't be heard at all), while 15 yields a high resonance (the cutoff
frequency is not as "strict," so some adjacent frequencies will be heard).
•
Extreme Type: This setting determines the effect of the Sweep Filters at the extreme low and high
ends. Select Kill for the filter extremes to end in silence, or select Bleed to allow the extreme end of the
filter to play.
Headphone
•
Attenuation: This is the gain level of the headphone output: -10dB to +10dB.
•
Split Cue Output: This sets which side of the stereo signal plays the Cue program on headphones,
Left or Right.
Microphone
These settings affect the microphones.
•
Attenuation: This is the gain level of the microphone inputs: -15dB to +0dB.
•
Gate Threshold: This setting changes the amount of audio required to engage the mic signal.
Different types of microphones may require this to be adjusted for best use: -40dB to -79dB.
•
Talk Over Level: This setting determines how much the master mix volume level is lowered when the
microphone talkover feature is activated: -40dB to -20dB.
•
Talk Over Resume: While using the talkover feature, the master mix volume will return to its normal
level after the microphone input detects no incoming signal. This setting determines whether that
transition occurs moderately (Normal) or quickly (Fast).
•
EQ High: This is the frequency band that will be affected by the High Mic EQ knob: 1,000Hz–
10,000Hz (in varying increments).
•
EQ Low: This is the frequency band that will be affected by the Low Mic EQ knob: 100Hz–900Hz (in
varying increments).
•
Booth Receive: Select On to allow the microphone signal to be sent to the booth outputs and record
outputs. Select Off to send the microphone signal to the master outputs only.
•
Headphone Receive: Select On to allow the microphone signal to be sent to the headphones. Select
Off to send the microphone signal to the master outputs only.
•
Reset Mic Default: Select OK to return the Mic settings to their default values, or select Cancel to
return to the previous menu.
FX
These settings affect the FX on X1850 PRIME.
•
FX Return: This is the unity level for the send outputs and receive inputs: -10dB–+10dB. You may
need to adjust this setting based on the types of external effects you are using.
•
Beat Break Edit: This menu enables you to select, edit, and store patterns for the BeatBreak effect.
See Effects > BPM Effect Module
To edit a pattern:
1. Turn the FX Select/Enter knob to select a pattern (1–16), and then press it.
2. Turn the FX Select/Enter knob to select one of 12 16th-notes in the pattern. You cannot edit the four
main beats of the pattern; they will always sound because they contain the audio being sampled.
Press the FX Select/Enter knob to change the beat from a "hit"/"strike" ( █ ) to a rest ( __ ) or vice
versa.
Repeat this step, if desired.
3. Press Back to return to the previous screen.
14
for more information about how this effect works.