Lamp Adjustment - Futurelight PHS-265 Bedienungsanleitung

Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 10 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
Procedure:
Step 1: Unscrew the fixation screws A and B of the lamp system and carefully remove it from the
housing.
Step 2: If replacing the lamp, remove the old lamp from the lamp holder.
Step 3: Insert the lamp into the lamp holder.
Step 4: Replace the lamp system in the housing and tighten the fixation screws.
Step 5: Adjust the lamp as described under lamp adjustment.

Lamp adjustment

If the light is brighter around the edge than it is in the center, or if light output is low, the lamp is too far back
in the reflector. "Push" the lamp out by turning the screws "1, 2, 3" counterclockwise ¼-turn at a time the
light is bright and evenly distributed.
Do not operate this device with opened cover!
The lampholder is aligned at the factory. Due to
differences between lamps, fine adjustment may
improve light performance.
Strike the lamp, open the shutter, set the dimmer
intensity onto 100 % and direct the light towards a flat
surface (wall). Center the hot-spot (the brightest part
of the beam) using the 3 adjustment screws "1, 2, 3".
Turn one screw at a time to drag the hot-spot
diagonally across the projected image. If you cannot
detect a hot-spot, adjust the lamp until the light is
even.
To reduce a hot-spot, pull the lamp in by turning all
three screws "1, 2, 3" clockwise ¼-turn at a time until
the light is evenly distributed.
40/120 51838205_V_1_1.DOC