Operation - HANSGROHE Focus E series Montageanleitung

Important! The fitting must be installed, flushed
and tested after the valid norms.
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the sink.
3. Slip the plastic washer, the slide washer, the metall
washer and collar over the hoses and threaded
base and tighten the collar nut by hand. If there
is not enough space, please use only the slide
washer and the metal washer without the plastic
washer.
4. Tighten screws.
5. Connect the supply pipes to the isolation valves;
cold right - hot left.
The hot and cold supplies must be of equal pres-
sures.

Operation

The mixer is activated by lifting the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water,
Technical Data
Operating pressure:
Recommended operating pressure: 0,1 - 0,5 MPa
Test pressure:
(1 MPa = 10 bars = 147 PSI)
Hot water temperature:
Recommended hot water temp.: 65° C
Rate of flow:
Test certificate
31780000/31786000:
Hansgrohe single lever mixers can be used toge-
ther with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 0,15 MPa.
To adjust the hot water limiter on single lever mixers,
please see page 21.
No adjustment is necessary when using a continuous
flow water heater..
English
max. 1,0 MPa
1,6 MPa
max. 80° C
11 l/min 0,3 MPa
WRAS
Spare parts (see page 4)
1 handle Focus E
1.1 screw cover
2 handle Focus S
3 flange
4 nut
5 cartridge cpl.
6 aerator cpl.
7 fixing set
8 connection hose 600 mm 3/8
9 connection hose 600 mm
10 sealing set
31795000
96338000
31797000
97995000
97996000
92730000
13913000
95049000
96556000
97997000
98702000