HP Latex 3000 Einführende Informationen Seite 12

Message or code
Printer cannot carry on printing
Printer cannot cool down
Printer cannot warm up
Printheads not aligned
Printhead replacement incomplete
Printing
Ready
Remove [color] printhead
Replace [color] cartridge
Replace [color] printhead
Replace aerosol filter
Reseat [color] cartridge
Reseat [color] printhead
Select substrate name in the IPS
Starting
Substrate jam: remove substrate
Substrate may be detached from
the rear spindle or slippage
detected. Substrate will be
unloaded.
System error
Very low cleaner roll
10.04.XX:YY
10.06.09:40
8
Recommendation
Check that the three-phase power supply is working and that the ambient
temperature is within the normal range. This problem can also be caused
by holes in the substrate, by reflective or transparent substrates, or by a
dirty or faulty temperature sensor.
If the ambient temperature is within the normal range, this problem may
be caused by removing the substrate too quickly after printing. Try leaving
the substrate in the printer until temperatures settle down after printing.
Check that the three-phase power supply is working. This problem can
also be caused by holes in the substrate, by reflective or transparent
substrates, or by a dirty or faulty temperature sensor.
Align the printheads.
The printhead replacement process was unsuccessful.
The printer is printing.
The printer is ready to receive and print a job.
Remove the printhead.
Replace the cartridge.
Replace the printhead.
Replace both aerosol filters.
Reseat the cartridge.
Reseat the printhead.
Select the name of the loaded substrate in the Internal Print Server.
The printer is being detected while starting up.
Remove all substrate from the printer (see the user guide).
See the user guide.
The printer has a system error. In the alert window, you should see the
numerical code of the system error.
Be ready to replace the printhead cleaning roll very soon.
Problem with e-cabinet fuses. You may need to run a subsystem
diagnostic to confirm that fuse replacement is required.
The emergency stops and/or safety relay have been activated. Check that
the emergency stops are not activated. If the problem persists, run a
diagnostic to identify the issue.
ENWW