HP Latex 3000 Einführende Informationen Seite 11

Message or code
Checking file system
Checking printer
Clean drop detector spittoon
Cleaner roll jam
Color calibration canceled because
of scanning errors
Connecting
Connecting printer, please wait
Disconnected
FW upgrade post actions
Ink drying
Ink system not ready to print
Job canceled due to lack of data
received from the IPS
Line sensor calib. error: substrate
too small
Low cleaner roll
Lower lever
Maintenance #N advised. Please
contact HP.
No substrate loaded
Please close safety sensor
Please press rearm button
Please release emergency stop
Preparing to print
ENWW
Recommendation
After a dirty power off, the printer performs a file system check, which will
take some minutes.
The printer is completing checks and cool-down cycle after finishing a job.
Clean the ink deposits.
Go to the Internal Print Server and select the Ink System menu, then Check
cleaner roll. Pull out the printhead cleaning roll assembly, raise the
pinchwheels, wind the roll forward manually, then lower the pinchwheels
and push the assembly back into the printer.
The color calibration chart could not be scanned successfully with the
current substrate.
The Internal Print Server is connecting to the printer.
The Internal Print Server is starting the printer.
The printer is shut down or not detected.
A firmware update is being performed.
The printer is drying the last passes of a job after printing it.
Please wait a while. If the printer does not recover, restart it.
If the problem persists, check the configuration of the built-in computer,
which runs the Internal Print Server.
Load a larger substrate.
Be ready to replace the printhead cleaning roll soon.
Lower the substrate pressure handles.
You are advised to contact your service representative.
Load substrate.
An open safety circuit has been detected, and should be closed in order to
continue working.
Press the blue, blinking button to finish the printer's start-up procedure.
An emergency button has been pressed, and must be released to continue
working.
The printer is performing checks and warm-up prior to printing.
7