Jacuzzi energy Bedienung Und Wartung Seite 11

not been completed and that the tank is empty (in any case, when
pressing the key, the alarm signal is interrupted).
The display does not receive commands
- If two keys are accidentally pressed at the same time, no fun-
ction is activated.
You will need to wait three seconds before giving a new command
- If the display is covered by a layer of water, it may not receive
commands.
Just wipe the water off with the palm of your hand and wait about
3 seconds before giving another command.
MAINTENANCE
ATTENTION! Before carrying out any maintenance op-
eration, disconnect the appliance from the power sup-
ply line.
Cleaning the air outlets
Remove any residue and wash the various components with wa-
ter and soap.
Cleaning the hydromassage outlets
Proceed as described above.
Cleaning the tub and the taps and fittings
Use non-abrasive or powder detergents (pay attention to the
writing on buttons).
Do not use acetone or other solvents.
Cleaning the headrest
Use a cloth or a soft brush and soap.
11 11