Installation Of The Hood - THERMEx Palermo Handbuch

COMPONENTS
the hood consists of the following elements (Fig. 1):
Hood body with a glass [a], equipped with lights and the fan unit,
the decorative cover consisting of the top funnel [c] and the bottom funnel [B],
Wall hanger of the hood and the hanger of the top decorative cover [e],
Set of mounting plugs.
INSTALLATION
to install the hood proceed as follows:
INSTALL ThE COOKER hOOD AT ThE APPROPRIATE LEVEL.
connect the hood to the ventilation duct.
connect the hood to the power network.
install the wall hanger [e] at the appropriate level.
install the telescopic column of the masking cover.

INSTALLATION Of ThE hOOD

trace a vertical line on the wall to indicate the center of the cooker plate,
Hold a cooker hood [a] to the wall (Fig. 3), set it symmetrically in relation to the central line, with
the distance between the holes in the profile and the cooker plate amounting to min. 960 mm,
level the hood preliminarily, indicate the spacing of mounting holes on the wall,
Drill the holes as indicated on the wall, using drills of diameter corresponding to the attached
expansion plugs, drive the plugs in and then screw the cooker hood body to the wall, and then
tighten the screw [H]
attach the telescoping column of the masking cover on the mounted hood (Fig. 1)
extend the top masking cover [c] (Fig. 1) to the required height, indicate its max. reach on the
center line, remove the cover,
Hold the hanger of the top masking cover [e] at the center line, at a distance of 65 mm from the
indicated point of max. reach, indicate the mounting holes on the wall and install the hanger as
described under d
install the masking cover column again and, using apprpriate screws, fix it to the bottom masking
cover and the top hanger profile,
connect the hood to the power supply network.
CONNECTING TO ThE POwER NETwORK AND OPERATION ChECK
after connecting the device to the power supply network (in accordance with the requirements
defined above) it is necessary to check the lighting of the hood and whether its motor works cor-
rectly.
the wall socket shall be accessible for disconnecting the plug after the hood is installed.
SETTING ThE AIR ExTRACTOR MODE Of OPERATION Of ThE hOOD
in the extractor mode air is discharged to the outside by a special conduit. in that setting any
carbon filters shall be removed.
the hood can be connected to the opening discharging air to the outside by means of a rigid or
flexible conduit of 150 or 120 mm diameter, and appropriate clamps for conduits which should be
english