Metal Grease Filters; Carbon Filter - THERMEx Palermo Handbuch

timer function can be cancelled by pressing t button again during counting of the time.
lock – keep about 3 seconds timer to block the control panel/keep 3 seconds to unblock the
control panel.
Note: the program always memorizes the last delay setting.
timer function has to be actuated within 20 seconds, otherwise the hood will return automatically
to normal operation.
the microprocessor system may get deleted or crash during momentary voltage drops in the
network, and stop responding to commands from the keyboard. in such case the hood has to be
disconnected from and then connected again to the power network in order to reset the system.

METAL GREASE fILTERS

1. cleaning.
Grease filters should be cleaned every two months during normal operation of the hood, in a
dishwasher or manually, using mild detergent or liquid soap.
2. replacement (Fig. 6).
to dismantle the filter proceed as follows:
a) remove the bottom cover by releasing the lock catch,
b) remove the metal grease filter

CARBON fILTER

operation.
carbon filters can be used only when the hood is not connected to any ventilation duct.
Filters with active carbon can absorb odours until they are saturated. they cannot be washed or
regenerated and should be replaced at least every 2 months or more frequently in case of very
intensive use.
2. replacement.
remove the metal grease filter,
remove the carbon filter situated on the aluminium filter (Fig.6)
install a new filter on the aluminium filter
LIGhTING
the lighting system consists of two halogen lamps of 20 W power each.
to replace a light bulb proceed as follows:
Using a flat tool or screwdriver prise the ring holding the halogen lamp glass (Fig. 8) and, holding
it, remove to the outside.
replace the bulb using a piece of cloth or paper for that purpose.
then reinstall the ring and the glass proceeding in reverse order.
Note: make sure that you do not touch the halogen bulb to be installed with your bare fingers!
english