Functional Description - Makita DTW181 Betriebsanleitung

attention right away. It may result in loss of
your eyesight.
5. Do not short the battery cartridge:
(1) Do not touch the terminals with any
conductive material.
(2) Avoid storing battery cartridge in a
container with other metal objects such
as nails, coins, etc.
(3) Do not expose battery cartridge to water
or rain.
A battery short can cause a large current flow,
overheating, possible burns and even a
breakdown.
6. Do not store the tool and battery cartridge in
locations where the temperature may reach or
exceed 50 °C (122 °F).
7. Do not incinerate the battery cartridge even if
it is severely damaged or is completely worn
out. The battery cartridge can explode in a
fire.
8. Be careful not to drop or strike battery.
9. Do not use a damaged battery.
10. The contained lithium-ion batteries are
subject to the Dangerous Goods Legislation
requirements.
For commercial
by
forwarding agents, special requirement on
packaging and labeling must be observed. For
preparation of the item being shipped, consulting
an
hazardous material
Please
more
Tape or mask off open contacts and pack up the
battery
manner
move
11. Follow your local regulations relating to
disposal of battery.
12. Use the batteries only with the products
specified by Makita. Installing the batteries to
non-compliant
in
excessive heat,
leak
SAVE THESE INSTRUCTIONS.
CAUTION:
Only use genuine Makita batteries.
Use of non-genuine Makita batteries, or batteries that
have been
in
bursting
personal
damage.
transports e.g.
third parties,
expert for
is
also observe
detailed national regulations.
in such
that it
around in the packaging.
products may
a fire,
explosion, or
of electrolyte.
altered, may
the battery
causing fires,
injury and
It will
Tips for maintaining maximum
battery life
1. Charge the battery cartridge before
completely discharged. Always stop tool
operation and charge the battery cartridge
when you notice less tool power.
2. Never recharge a fully charged battery
cartridge. Overcharging shortens the battery
service life.
3. Charge the battery cartridge with room
temperature at 10 °C - 40 °C (50 °F - 104 °F).
Let a hot battery cartridge cool down before
charging it.
4. Charge the battery cartridge if you do not use
it for a long period (more than six months).
FUNCTIONAL
DESCRIPTION
CAUTION:
switched off and the battery cartridge is removed
before adjusting or checking function on the tool.
Installing or removing battery
required.
possibly cartridge
CAUTION:
installing or removing of the battery cartridge.
a
cannot
CAUTION:
cartridge firmly when installing or removing
battery cartridge.
result
►
Battery
To
result
front of the cartridge.
To
also
7 ENGLISH
void the
warranty for
tool and
Always be sure that the tool is
Always switch off the tool before
Hold the tool and the battery
Failure
the tool
battery cartridge
cause them
off your
result in
the tool
cartridge and
personal injury.
Fig.1: 1. Red indicator 2. Button 3.
cartridge
remove the
slide it
tool while sliding the button on the
install the
align the
Makita
the Makita
charger.
to hold
and the
firmly may
to slip
hands and
damage to
and battery
a
battery cartridge,
from the
battery cartridge,
tongue on