Makita DTW181 Betriebsanleitung Seite 10

You can change the impact force in three steps: hard,
The function
with
rotation. When the bolt/nut gets enough loosened, the tool stops the impact and rotation.
For approximately
the
Impact force grade displayed
on panel
Hard
Soft
Reverse rotation auto stop
mode
NOTE: Reverse
the
rotation auto stop mode, the impact force and speed are the same as Hard impact mode.
NOTE: When
the
power.
pulling
tool
NOTE: While pulling the switch trigger, the impact force grade cannot be changed.
soft, and Reverse rotation auto stop mode.
of Reverse
pulling the
one
impact force
Maximum blows
-1
3,600 min
-1
2,000 min
-1
3,600 min
rotation auto
tool rotates
all lamps
tool is
The impact
the switch
does not
This allows a tightening suitable to the work.
Every time
rotation auto
trigger fully
minute after
can be
(/min) Tightening when force and
speed are desired.
(/min) Tightening
(/min) Loosening with auto stop
function.
stop mode
counterclockwise.
on the
turned off
force grade
trigger to
operate.
10 ENGLISH
the
pressed, the
blows changes in three steps.
stop mode
in counterclockwise
releasing the
changed.
Purpose
Assembling steel frames.
when you Assembling furniture.
need fine
adjustment with
small
diameter bolt.
Disassembling bolts/nuts.
is available
When rotating
switch panel
to save
can be
the extent
button is
number of
works only
tool
switch trigger,
Example of application
only when
clockwise in Reverse
go out,
the battery
checked by
that the