General Information; Installation Dimensions - Novy Akan Bedienungsanleitung

GENERAL INFORMATION

The gas hob is manufactured using sustainable materials. The
packaging is recyclable and consists of the following types of
materials:
- paperboard
- paper
These materials are in accordance with the provisions of
Government to be disposed of in a responsible manner. The
packaging of this product is equipped with a sticker with the
image of a crossed-out dustbin (see fig. 9).
fig. 9
The directive on waste electrical and electronic equipment
(WEEE) of the European Union. The WEEE directive of the
European Union requires that products that are sold in the
countries of the EU (or in some cases the packaging thereof)
must be labelled with a crossed-out dustbin. As determined
by the WEEE directive, this means label with the crossed-out
dustbin that customers and end users in the countries of the
EU electrical and electronic equipment or accessories not with
the garbage may dispose. Customers and end users within the
EU should contact their local supplier or maintenance centre
for information about the waste collection system in their
municipality.

1 INSTALLATION DIMENSIONS

Top (TS) measure in mm
Min. 47
Min. 150
Min. 600
Min. 50
– The gas hob module cannot be installed over a partition of
cabinets. It has to be accessible in case it needs servicing.
– When the gas hob is combined with a drawer cabinet,
always be aware of the measurements of the unit and the
support bar. The height of the unit and the support bar is
119 mm (TS) measured from the top of the worktop (fig.2).
– To prevent bending of the worktop the appliance need to
be supported by two support bars (fig. 2 and 3).
fig. 2
Between the gas hob and the one above it installed cooker
hood, a minimum safety clearance (X) as specified by the
manufacturer must be maintained.
If this information is not available, keep than a distance of at
least 650mm. Even if there are highly flammable materials
above the gas hob, this distance must be observed.
Support bar
Min. 4
Max. 35
Support bar
fig. 3
– 27 –
Min.
X
Min.
450
119 mm
89 mm
Support bar