Getting Started - REVELL Control DEMONSTRATOR GSY 24034 Bedienungsanleitung

1. GETTING STARTED:

The throttle stick (the left stick on the remote
controller) must be pointing down when you
turn the controller on. Switch the controller to
"ON" (pic. 1); the Power LED turns red and the
Start control LED fl ashes. Move the throttle
stick up and then down until the control LED
lights up continuously.
2. TRIMMING THE CONTROLLER:
Correct trimming is crucial for ensuring that the helicopter fl ies smoothly. It is easy to do, but does require a little patience and a light touch. Please follow these instructions carefully:
Slowly move the throttle stick up to raise the helicopter to an altitude of about 0.5 metres to 1 metre.
3. FLIGHT CONTROL:
To take off or to make the helicopter fl y higher, carefully push the throttle stick upward.
To move forward, carefully push the direction stick forward.
To make left turns, carefully push the direction stick to the left, provided that
the tail of the helicopter is pointing towards the pilot.
RC_Anleitung_Micro_Helicopter_Demonstrator_03.indd 7 RC_Anleitung_Micro_Helicopter_Demonstrator_03.indd 7
Flying the Helicopter
pic. 1
If the helicopter keeps turning quickly or
slowly to the right or left ...
If the helicopter keeps turning quickly or slowly to the right or left, then briefl y touch the opposite trimming urnin
buttons until the helicopter stops turning on its own. Never just hold down the trim buttons continuously.
Now switch the
ON/OFF switch
on the underside
of the helicopter
"ON".
To land or descend, move the throttle stick backward. The stick only needs to be
moved very slightly to ensure smooth fl ying.
To move backwards, carefully pull the direction stick back.
To make right turns, slowly push the direction stick to the right, provided that
the tail of the helicopter is pointing towards the pilot.
Place the Place the helicopter
on the fl o on the fl oor with its
tail facing tail facing you.
7
18.02.10 15:15 18.02.10 15:15