Husqvarna CL400 Bedienungsanweisung Seite 8

1. Loosen the rear handle (2) of the handlebar
counterclockwise and remove the knob (1).
2. Select the height.
3. Install the knob in the new hole.
4. Tighten the handle clockwise.
To adjust the inclination of the
handlebar
The handlebar can be tilted to avoid obstacles.
The inclination of the handlebar can be adjusted in four
levels both on the right and four levels on the left.
1. Pull the lever placed on the lower left side of the
handlebar fully.
2. Put the corresponding pin in one of the nine holes
located on the rack at the bottom of the handlebar.
To lock the swivelling blade
Lock the swivelling blade to ensure greater precision of
the product direction when the cable has to be put over
long straight sections.
8
• Tighten the handle (1) on the right side of the
support device.
To adjust the width of the wheels
Both wheels are equipped with 4-position adjustable
drive shafts (1). The cutter can be adjusted at 25, 27, 29
or 31 cm from the adjustable edge.
1. Pull out the locking pin (2).
2. Put the locking pin (2) in one of the 4 holes lon the
drive shaft (1).
3. Lock the safety spring.
To start the work
After the cable and the cutter are installed, the operator
need to fix the cable to the ground.
1. Put a stake into the ground.
2. Fasten the part of the cable that comes out from the
bottom of the blade to the stake.
1394 - 002 - 27.11.2019